Following on from the forum Dan sat on at the Yacht Racing Design & Technology Symposium in December 2010 www.yrdts.com, here are some of the details of the lightweight, cored and most importantly, cheap, high performance composite panels that were showed at the conference.
This process is one that was developed specifically for the automotive markets, and is traditionally used for rear parcel shelves and boot floors.
During a previous high volume, low-cost car program Dan worked closely with Bayer to develop the process and materials so that we could produce extremely complex 3D parts, that could be used to form the main panels of the chassis. Whilst we cannot obviously show these panels here, we have some small sample sections that will give you an idea of the type of geometry possible.
The process uses Polyurethane as the matrix (rather than the traditional Epoxies and Polyesters usually used in such products). This has an extremely fast cure profile and can be cured in about 90 seconds if required. In fact, from dry cloth on a roll to a fully cured, net edge part ready to be bonded in the chassis was just over 2 minutes... Where these high volumes are needed (up to about 300,000 parts per year) robots are always used to spray the PUR and can also be used to spray additional Chopped fibres into areas that require additional local reinforcements. Dan worked very closely with a company called Hennecke in Germany www.hennecke.com to ensure that all the possible avenues were explored to produce the most efficient (cost and performance) parts.
Whilst these throughput times are perhaps not appropriate for most marine applications, they may allow the designers to produce extremely lightweight, low cost panels such as doors, floorboards. Where a boat manufacturer may perhaps be producing a reasonable boats in a range, if every boat had the same size doors, and every boat has say 3 doors, then the volumes very quickly reach a number that is ideal for this type of process. In fact, on some super yachts, which can have 150m2 of floorboards which are traditionally made from 25mm ply wood, the weight saving could be over 5kg per m2 (i.e 50% of the baseline boards)
If any further details are required or if you may have a possible application for this process, then please contact us at any time at Info@LightBlackDesign.com
No comments:
New comments are not allowed.